Hey folks, I'm following a tutorial and doing the usual: - create the vertical profile curves. - create a horizontal curve guide to help with volume of the surface. - extrude it/ hide the profile curve. - select the all the vert curves and loft a surface. - then select the horizontal curve to give new the surface some volume. BUT, I'm having issues. Two images here, one is from the tutorial I'm following and the other image (with the red circle) is my doc. So in both examples it followed the steps above. in both examples both horizontal curves had blue connected point as the junction. The difference is I extrude the profile my horizontal curve point turns red (not connected) while in the tut it stays bleu (connected). So of course I can make a loft surface from the vert curve BUT as soon as I select the Horizontal curve it fails. Anyone else have this happen? Any thoughts? Thanks!