Hi everybody looking some advice on this w176 a class. So on the dashboard it says airbag light fault and active bonnet malfunction (safety device for a crash). Diagnostic scan done with genuine xentry, scan tool showed no faults for active bonnet malfunction and in the airbag ecu showed a fault for internal fault in airbag ecu. All can bus block connectors show 2.3v and 2.7v apart from this black and white can bus block connector. It shows 2.4v and 2.5v. Scoped the can bus via breakout box at 16 pin obd and it shows in my opinion a bad waveform pattern. Also the carpet was heavily soaked and removed from the car, this canbus connector earth had some green corrosion but cut out and replaced but still no difference. Any ideas where to go next?

what scan tools do you have and what is the one feature you use the most on that scanner iv got a oto fix d1 and a top don phoenix elite i use the topdon the most and use the BMW service write to the idrive we service a lot of BMW

7.30 link in the calendar

Are you up for the challenge??

Not strictly automotive but relevant. Called out to take a look at a solar setup after their ‘electrician’ had condemned and replaced the charge controller and still had the same issue. ‘You can see voltage with the meter so what’s the problem’ Yeahhh that’s the problem.