Bottom end decisions · The LS & LT Swap Community

Bottom end decisions

OK guys, I need some opinions about my 6.0L build. It was a core engine that I picked up cheap and ended up only being a collapsed lifter, everything else looks fine. I'm already going to be removing the rotating assembly to install new bearings, but at what point do I go with a better than stock rotating assembly? this is a Gen 4 engine, so I know the internals can handle a bit more in stock form, but at what point do I go ahead and start swapping parts out? its kind of turning into a "well, since I'm already here" type of thing, and I'm not sure that's warranted

5 comments