What is improved? A small ring 3 mm thick with a 20mm diameter and 7 mm hole is added to the top of each cone to serve as a guide and create perfect alignment with the copper spikes at the exact center of the configuration. (Look the first image At the bottom, the Spiraling sections are trimmed, and this allows a flat base for better adhesion with the 3D printing Bed. Without this adjustment, I`m not sure if it's even possible to be 3D printed with FDM printer. You can download the Files from here if you want, and also a small 19.5 Degree cone is added as well, with 33.3cm height for those of you who want supper low budget option to experiment. This 19.5 Degree STL can be used as a mold for Fiber Glas or Kevlar, Carbon Fiber or other composite materials to create the cones and later use it as a base for the copper wire, which might be 0.35mm thickness. Basically, to use the same method that I created the previous cones, but smaller and with thinner wire. The Idea here is to create 2 or 3 Identical cones and see if they can transfer the power over a greater distance or can be used to activate the space-time antennas instead of using standart Tesla Transformer. The total cost for all 5 files was a bit less than 200Euro including shipping and the order is placed today. We can now see if this can actually be printed with PETG, and if yes what will be the quality. If these files are working, anyone can print them and make the cones very easily.

Just placed the order for the Fibonacci spirals on https://jlcpcb.com/ you can download it from here and also see what Options I chose when placing the order. The total cost is 203 Euro including delivery and VAT for 5 pieces. I hope this call allows us to print the Fibonacci spirals (Flash Matrix) easily, without the need to assemble it with polycarbonate and copper wire and soldering it manually, which is pretty hard and takes time, and is more expensive per piece. Notice that up to now I was using 1mm copper magnet wire but now in the PCB we are using 1 oz copper thickness: 35 µm (1.4 mil). This seems way tinner but it is external and is not coil, because of that we can run almost 4 amperes, which is way more than we actually need. (1 mm wide, 1 oz copper trace (external layer, 10°C rise): ~3–4 A. Most IPC-2221 based sources give ~3.5–4 A). The PCB option is also 1.6mm thick Material Type: S1000H TG155 instead of 9-10 mm policarbonate used so far, this will reduce the distance between the copper hemispheres and increase the capacitance to some degree. If you decide to place an order for yourself, you need to choose Surface Finish: ENIG, which will allow you to choose copper edging that is necessary to make the inner and outer rings, where both sets of the spirals are connected (see the images attached) If some of you manage to create the 30 cm Copper hemispheres, I can send him one of these PCBs because there are 5pc and I might not be able to use them all.

Not gone, just busy~! This is my new cone design. It resonates at 2.757mHz. Working on the next one. The goal is to get them both resonating at the same frequency before connecting them together.

I belive N.Tesla wanted to replicate this idea with the Tesla Towers, making the entire planet into a sphere where the signal from one tower is multiplied and can be received to any point of the surface tnesion. In this way the Earth is like a conductor which is hyperconductive and emit the power or the signal in all directions at ones. This is also the main idea behind the Spherical Space Time Antenna. In Alchemical manual is called the True Principle of Multiplications

https://www.youtube.com/watch?v=i2DoBy3TlGA