2d • General discussion
Here is Improved version STL files for the cones
What is improved?
A small ring 3 mm thick with a 20mm diameter and 7 mm hole is added to the top of each cone to serve as a guide and create perfect alignment with the copper spikes at the exact center of the configuration. (Look the first image
At the bottom, the Spiraling sections are trimmed, and this allows a flat base for better adhesion with the 3D printing Bed. Without this adjustment, I`m not sure if it's even possible to be 3D printed with FDM printer.
You can download the Files from here if you want, and also a small 19.5 Degree cone is added as well, with 33.3cm height for those of you who want supper low budget option to experiment.
This 19.5 Degree STL can be used as a mold for Fiber Glas or Kevlar, Carbon Fiber or other composite materials to create the cones and later use it as a base for the copper wire, which might be 0.35mm thickness. Basically, to use the same method that I created the previous cones, but smaller and with thinner wire.
The Idea here is to create 2 or 3 Identical cones and see if they can transfer the power over a greater distance or can be used to activate the space-time antennas instead of using standart Tesla Transformer.
The total cost for all 5 files was a bit less than 200Euro including shipping and the order is placed today.
We can now see if this can actually be printed with PETG, and if yes what will be the quality.
If these files are working, anyone can print them and make the cones very easily.
5
1 comment
Here is Improved version STL files for the cones
powered by
skool.com/allistar-center-4289
This is the Metafusion community blending Technology with Consciousness, Science with Metaphysics. We connect what seems to be polarity into one idea.
Suggested communities
Powered by