7d • General discussion
Flash Matrix Spirals Update
What has changed for the next prototype?
- Realizing that Fibonacci Spirals can be built in different ways. Thye can be Logarithmic (smooth) or built from 1/4 arcs of a circle. In the 4th image you can see the difference between the two. On the left are spirals that are built from 7 different length squares starting from 6.1mm and then multiplying next iteration by 2-3-5-8-13-21 times. The diagram is shown in image 3 this form a grand circle of 300mm diameter. Notice that when the spiral transition from one iteration (octave) to another, there is a pattern that forms, which is perfectly concentric. You can see 3 or 4 of those concentric circles because the rest are very small and are inside the inner ring and the quartz crystal, but they are 7 Octaves.
These concentric rings are what the Pleiadians called Magnetic Dinner Plates, and you can see how each octave has its own resonant frequency and bandwidth, creating the different colors and their predominance.
2. The Dielectric disc now has one set of spirals, 34 on one end, and the other set, 21 on the other end. This gives perfect positioning of the quartz crystal and the spirals exactly at the equatorial plane. This is important, according to Bashar, because otherwise it could create a feedback loop and cancel the desired resonance. Up to now bot sets were on top of the dielectric and 3-3.6mm on the bottom was solid dielectric.
3.The inner ring is more solid and perfectly concentric, but also will accept the spirals from top and bottom instead of radially, and the spirals will also be soldered to eliminate noise, not like up to now just mechanically connected. The inner ring will be 25-3mm wide and 3mm tall with 55 holes of 1mm in diameter.
4. Both discs can be done with MJF 3D printer and black PA12 Nylon (cheaper option with risk of warping or deformation, which is hard to estimate) from Craftcloud3d for 120 Euro, or CNC and transparent Polycarbonate from JLCCNC for 185 Euro with the rings if they approve the discs after evaluation (pending)
5. Quartz Crystal Sphere found 100$ 40mm, perfect quality for the Flash Matrix, only with a central 5mm hole, the 4 wires of the spirals will be attached on top and the bottom of the crystal because I can solder them instead of just inserting them into the central rod through the crystal. Bashar confirms that this is also a valid way to connect as long as they are 90 degrees perpendicular to each other.
6.Outer ring, I'm thinking of making it from a 5mm wide copper strip, cut it with the CNC router here, and soldering the ends with argon and TIG. Spirals will go between this strip and the disc, there is 1mm channel for this, like a groove. If this doesn't work, plan B is to use 1mm thick wire on the edge and solder all the spirals to it, like up to now.
2
3 comments
Flash Matrix Spirals Update
powered by
skool.com/allistar-center-4289
This is the Metafusion community blending Technology with Consciousness, Science with Metaphysics. We connect what seems to be polarity into one idea.
Suggested communities
Powered by