Here. I have a good one to get this post going. I made an epoxy card table top for an old bar. When I made the top, I obviously made it larger than I need so I can trim it down and clean the edges. But I failed, I only made it like 1/2 inch all around larger than I needed. I should have gone about an inch all around. My thought now, just square it up so it looks pretty, which will make it too small to fit the groove it needs to fit in, but then add some type of border (frame it in) to the correct size. Not sure the best way to handle that. Wondering if anyone has a better solution.

Awesome.