First, it sounds like you’re hitting a usage cap on Creatorly’s AI module builder. Many of these AI-based course platforms set low limits on free or basic plans — they’ll say you can “create unlimited modules,” but the AI credits for auto-generating lessons run out fast.

My advice: - Double-check your plan details and upgrade options — sometimes a higher tier unlocks more AI credits. - If the AI is blocked, pivot: draft your module structure manually first in Google Docs, then use Creatorly just for uploading and hosting. - Start looking for alternatives with better support. Tools like Thinkific, Teachable, or Kajabi aren’t as AI-focused, but they’re reliable, with real support teams and easy module creation.

From what you’ve described, there are a few key points: - The original manual entry worked because the trigger conditions in Workflow 3 were aligned properly (most likely “Enroll on calendar event registration”). - The current misalignment — “Enroll on page view” — has caused a logic mismatch. Because your calendar event and the page view were technically linked, the workflow should have caught them, but it didn’t, likely due to cookie/session mismatches for contacts added manually. - When you tested by adding a team member, the system saw that they skipped all wait conditions and instantly received every email in the sequence. This indicates that your Workflow 3 is likely built with immediate “send email” steps instead of delays based on relative dates or a “wait until” logic tied to the offer closing date. ✅ Recommended Solution Here’s what I’d do to fix this without spamming your contacts: 1️⃣ Check Your Workflow 3 Logic - Confirm that your Workflow 3 is set up with relative date-based wait steps or condition-based delays (e.g., “Wait until X date,” “Wait until 3 days before event,” etc.). - If you have only instant “Send Email” steps, any new contact will get all emails at once. That’s exactly what happened with your team member test. 2️⃣ Temporarily Pause the Workflow - If possible, put Workflow 3 in a paused state. This prevents an accidental mass send while you adjust the triggers and conditions. 3️⃣ Adjust Trigger Conditions - Switch the trigger back to “Enroll on calendar event registration” or another reliable action that you can manually control. - For these 7 contacts, double-check that they are indeed marked as registered for the correct calendar event. 4️⃣ Manually Enroll Using a Safe Method - Before re-enrolling these contacts, test the entire sequence with a test contact and verify that the wait steps hold as expected. - Only when you see that your test contact enters the workflow but does not get all emails instantly should you batch-add the 7 contacts.

@Abeer and Somya Desai You're welcome!

So gooddd

Thank

Thank u so much