(MOST SMALL E-SCOOTERS) In this course we are going to show how to make a Generic inner tube replacement on a basic e-scooter! This video will answer alot of questions on how to change a flat tire on an e-scooter. In this video we are specifically repairing the i-III from iScooter. This scooter uses 8.5x2 inch straight valve stem inner tubes which you can buy straight from ScooterOps.com just send us an email!

HiBoy X300 E-Scooter Rear Flat - Part 1 -In this video Scooter Operations of Phoenix is fixing a Rear Flat on a HiBoy X300 We are specifically fixing the Rear Wheel (Motor Cable quick Detach) on the X300 from HiBoy. Visiting Phoenix? Need an E-Scooter? Visit Scooter Operations of Phoenix at [www.scooterops.com](www.scooterops.com) !

HiBoy X300 E-Scooter Rear Flat - Part 2 In this video, ScooterOps finishes changing out the Rear Flat on a Hiboy X300. This e-scooter wheel uses an 12.5" x 2.25" inner tube with an angled valve stem. We show how to put the wheel back on and stabilize the inner tube- which we thought we didn't have the right size, but upon research at Hiboy.com we found that it is in fact the right size tube. The tube is linked in the resource files.

What's in the Scooter Operations E-Scooter Repairs Toolbox? -- Showing ALL of our tools necessary to fix ANY problem on ANY e-scooter AND be MOBILE. All tools fit inside a 8 x 14 x 10" Tool Box To be "mobile" just grab an air compressor that plugs into your cigarette lighter in your car. Pretty Awesome if you ask me.

Gotrax Tour XP Rear Flat E-Scooter - Part 1; PART 1 on how to fix a GOTRAX TOUR XP REAR FLAT... If you have any questions on E-Scooter Repair please email chris@scooterops.com

Gotrax Tour XP E-Scooter Rear Flat - Part 2; Part 2 of the GOTRAX TOUR XP REAR FLAT. We try to put the tube back into the split rim. We encounter a hiccup. We learn from our mistakes. It is important not to rush when installing the tubes.

Gotrax Tour XP E-Scooter Rear Flat - Part 3, We had to go part 3 for this one we finish the split rim tube install on the GoTrax Tour XP Rear Wheel after tearing the tube accidentally in Part 2. We don't quite fully get the tire on on camera, but we show the proper hand tools used and how to do it properly. The course prices are thus reflective of 'the shot' quality of the Video and what I am able to show on camera. I will have much better quality videos as time goes on. Thank you

HiBoy X300 E-Scooter Front Flat - Part 1 Scooter Operations of Phoenix is fixing a FRONT FLAT on a HiBoy X300. This e-scooter wheel uses an 12" x 2.5" inner tube with an angled valve stem. This e-scooter was a simple fix! The only tools you need are an adjustable wrench, tire spoons, and a #4 mm Hex Wrench or multi. Tire Spoons are linked in the resource files. The tube is linked in the resource files. The E-Scooter and issue being Repaired today is: HIBOY X300 FRONT FLAT (A MOTOR WHEEL? NO)

Aovo Pro Esmax Rear Flat - Part 1 Scooter Operations of Phoenix is fixing a REAR FLAT on a AOVO PRO ESMAX. This e-scooter wheel uses an 10" x 2.50" inner tube with an angled valve stem. This e-scooter was a simple fix! The only tools you need are an adjustable wrench, tire spoons, and a #2.5 mm Hex Wrench or multi. Tire Spoons are linked in the resource files. The tube is linked in the resource files. The E-Scooter and issue being Repaired today is: AOVO PRO ESMAX REAR FLAT (A MOTOR WHEEL? YES)

Aovo Pro Esmax E-Scooter Rear Flat - Part 2 We are fixing a REAR FLAT on a AOVO PRO ESMAX. This e-scooter wheel uses an 10" x 2.50" inner tube with an angled valve stem. This e-scooter was a simple fix! The only tools you need are an adjustable wrench, tire spoons, and a #2.5 mm Hex Wrench or multi. Tire Spoons are linked in the resource files. The tube is linked in the resource files. The E-Scooter and issue being Repaired today is: AOVO PRO ESMAX REAR FLAT (A MOTOR WHEEL? YES)

Apollo Phantom E-Scooter Front Flat - Part 1 The Virtual E-Scooter Repairs Shop attacks the Front Flat on an APOLLO PHANTOM . This would probably very similar to a V 2.0 as well. We first attack the lug nuts with an 18mm wrench... then the wheel comes off but it is held by the motor wire. This wheel IS A SPLIT RIM so we just use a 4 mm to attack it. We will then remove the tube from the tire and then identify the size of the tube and order the tube. When it comes in we can film PART 2.

Apollo Phantom E-Scooter Front Flat - Part 2 The Virtual E-Scooter Repairs Shop attacks the Front Flat on an APOLLO PHANTOM . This would probably very similar to a V 2.0 as well. We are putting humpty dumpy back together again. We are putting the SPLIT RIM back on and stabilizing the tube. This video shows a really good technique for split rim reassembly.

Apollo Phantom E-Scooter Rear Flat - Part 1 The Virtual E-Scooter Repairs Shop attacks the Rear Flat on an APOLLO PHANTOM . This would probably very similar to a V 2.0 as well. We first attack the lug nuts with adjustable wrench... then the wheel comes off but it is held by the motor wire. This wheel IS A SPLIT RIM so we just use a 4 mm to attack it. We will then remove the tube from the tire and then identify the size of the tube and order the tube. When it comes in we can film PART 2.

Apollo Phantom E-Scooter Rear Flat - Part 2 This is PART 2 where we simply are "Putting Humpty Dumpty Back Together Again."

Tifgalop T88/T88+/Other Front Flat Part 1 - We are changing a Tubeless Tire into a Tubed Tire by flaming out the Tubeless mechanism. In this video, we talk about which tube will work with this size tire (100/65/6.5 and 90/65-6.5). This is Part 1 of the 2 Part series where we, as always, remove the wheel, remove the tire, identify the tube, order the tube, and wait for it to come in before filming and going on to Part 2 where we "put humpty dumpty back together again."

Tifgalop T88/T88+/Other Front Flat - Part 2 - We are putting Humpty Dumpty Back Together Again with the New Tube Ordered Turning this once tubeless tire into a Tubed Tire

Tifgalop T88/T88+ Rear Flat - Part 1 As we take the tire off in this one it is more difficult than normal The technique(s) shown in this video may also work for many other similar Tifgalop models. In this video, we talk about which tube will work with this size tire (100/65/6.5 and 90/65-6.5). I am confident that this "tubeless mechanism," "removal technique" with torch or drill shown in the Front Flat Video and I may cut it into this one as well would work on many other Tifgalop models.

Tifgalop T88/T88+/Other Rear Flat - Part 2 Putting Humpty Dumpty Back together again; all tools and e-scooter parts linked in skool resource attachments page

Ausom Leopard Front Flat Fix - Part 1

Ausom Leopard Front Flat Fix - Part 2