Im going to have to check time zones to see if i can show up

@Annelize Erasmus no its vynil wrapped .It took me a full day to design wrap and build .( About 12 hours) start to finish

@Annelize Erasmus no not usually but i did have more free time that day to focus on it and i had a narrow deadline so i only had one other job open on illistrator next to this one

@Annelize Erasmus i found the file on etsy but i didnt pay attention to the lengths so it took forever to getbthem lined up lol

@Annelize Erasmus yes the wall and pillars were still fairly fresh about a week set up for the concrete and mortar .

Doesnt look like a head strike maybe some clogged lines in the back or a pump

@Annelize Erasmus oh no!! Yeah i can see it in the picture , i hope you get this resolved its never fun to have a piece of equipment down . I would be checking for leaking feed tubes for or bad pumps for the missing ink and maybe one of the drive gears has come loose that drive the belts? On a flat bed cnc its pretty common for a set screw to come loose on a drive gear on it shows the cuts being off in wierd directions during running where the gear will spin for a second and then catch again going the other direction