Ok, so I had an issue today when the plumber came to install my bathroom fixtures. The shower mixer is sitting too far into the wall. Obviously there's been some kind of miscommunication with measurements. The plumber did the rough in and I know I told him the wall was being framed out 90mm. Then I have 6mm villaboard plus tiles on top. It looks like he didn't allow for the thickness of those, as the mixer is only just sticking out of the wall, so the trim kit won't connect to it properly. I also have in pictures evidence that the carpenter modified the plumbing installation as he had to install a stud where the bar that the mixer was screwed to is sitting. So maybe the new bar was narrower. Who knows, but here we are... I think I have found a solution by using a mixer body extension kit. If there is one available for my mixer, it should be fine. If not, I will have to cut a hole in the tiles and villaboard and push the mixer forward about 10mm, hoping the pipes have enough flex. Then patch up the hole, patch the membrane and tile. I would give anything to avoid that. I'm a little bit devastated but at the same time I expected it. Everything going smoothly would have just been too much to hope for. I will find out tomorrow if I can do the easy fix with an extension kit. 🤞🤞