Hi everyone, have a s class I'm a bit stuck with at the minute. 360 camera that gives a bird eye view not working, tried software update also to fix it it but have this problem in video. So the module has can high and low, 12v supply and earth and they are all fine so I’ve checked all the inputs. All outputs are 4 cameras, front, rear, left wing mirror and right wing mirror. All these have 5v feed and all seem drop down to under 1 volt. I’ve checked them with a multi meter and can confirm they do the same thing on the multimeter not just live data. There’s another output to the head unit (centre screen/radio) and it seems fine also. Who thinks the module is faulty but no fault codes in it?

Hi everybody looking some advice on this w176 a class. So on the dashboard it says airbag light fault and active bonnet malfunction (safety device for a crash). Diagnostic scan done with genuine xentry, scan tool showed no faults for active bonnet malfunction and in the airbag ecu showed a fault for internal fault in airbag ecu. All can bus block connectors show 2.3v and 2.7v apart from this black and white can bus block connector. It shows 2.4v and 2.5v. Scoped the can bus via breakout box at 16 pin obd and it shows in my opinion a bad waveform pattern. Also the carpet was heavily soaked and removed from the car, this canbus connector earth had some green corrosion but cut out and replaced but still no difference. Any ideas where to go next?

What we got going on today?