Sometimes things dont go to plan and that's ok! Ran out of filament with 13hrs of print time left... I thought I had refilled it and off the printer went.. Hours later when I checked back I noticed that something just wasn't right 🤦‍♀️🤦‍♀️ I tried using my software to *cut* the design but it was hard figuring out what point to cut it (newbie) It lined up ok but still not perfect but it was cool to see just how big the jumbo ducks would be!

Is anyone finding these points very sharp? @Darryl Cross could these be rounded a bit? I've just been melting them so far.

I am at the desk for 1 hour before I have to leave . Did everyone here who paid for files get the files ? I am just asking. If you did get the files, have you done a test print yet ? If so can you please post a pic of it in the comments ?

I Started 3 prints last night, I woke this morning and all 3 machines had failed. I am starting to hate printing with GEETECH SILK GOLD PLA. I have had 7 failures over the past 3 days. Shits driving me crazy

Is everyone here good with support settings ? Are yall using TREE SUPPORTS ? Do they break away nice or are you having to use pliers ? Should I post a pic of my support settings to help US out or is everyone cool with their current settings ?