Hi everybody looking some advice on this w176 a class. So on the dashboard it says airbag light fault and active bonnet malfunction (safety device for a crash). Diagnostic scan done with genuine xentry, scan tool showed no faults for active bonnet malfunction and in the airbag ecu showed a fault for internal fault in airbag ecu. All can bus block connectors show 2.3v and 2.7v apart from this black and white can bus block connector. It shows 2.4v and 2.5v. Scoped the can bus via breakout box at 16 pin obd and it shows in my opinion a bad waveform pattern. Also the carpet was heavily soaked and removed from the car, this canbus connector earth had some green corrosion but cut out and replaced but still no difference. Any ideas where to go next?

https://www.skool.com/rms-auto-electrics-diagnostics/classroom/1cdc0057?md=e45c36029b4f4eb3bd9bbd1cf01d4954

7.30 link in the calendar

post all chat here!!!

Are you up for the challenge??