23h • General discussion
Pipe Welding
Heres a few shots of some Super Duplex SCH160 1.5"DIA pipe ive been working on. The fabrication is a cooling coil for the Oil and Gas sector, I cant post the actual job but this is an extra joint that had to be cut out and i thought it was perfect to post here.
Root - 70A
Hot pass - 100A
Fill - 105A
Cap - 115A
The WPS specifies an interpass temp of 60°C that must be adhered to.
All welds on the job are 100% X-RAY, including DPI and a ferrite check before pickling and passivation.
2
12 comments
Pipe Welding
skool.com/motofab-performance
1. Real time advice to level up your skills
2. Free settings reference sheets
3. Created by a Lockheed Martin welder for those serious about Fab
Leaderboard (30-day)
1
+49
2
+46
3
+33
4
+30
5
+30
Powered by