Dec '25 • General discussion
First time welding a roll bar
Ok guys thisnis my first attempt at welding a roll bar i got for my E30 K swap. Its a .120 wall DOM mild steel kit from garagistic. It has all the copes pre cut and the fit so far seems to be ok. I do have some sections that I will not use and I am using them to dual in settings.
Right now im settled at 128a with 1.5s/8s of flow and am using 1/16 filler. My speed is slow and im pushing a lot of rod to fill the valley. Ill let Sensei Grant critique it from here.
2
6 comments
First time welding a roll bar
powered by
skool.com/motofab-performance-7936
1. Real time advice to level up your skills
2. Free settings reference sheets
3. Created by an aerospace welder for those serious about Fab
Suggested communities
Powered by