6d • General discussion
Very warm welcome
I want to welcome our new members from all over the world. It’s great to have you here. I hope you’re all having a nice weekend.
If anyone has any content ideas, please leave comments, start a new post or message me privately. I want to create videos around your trouble areas. Labels, reports, using Fab parts in Revit, anything you need a bit of help with.
If you’re are happy with me recording what I think you might want to see based on what my customers typically as me when I make workshop site visits, then I’ll keep going with my own content, but I would really like the members to have as much input as possible so I can tailor to your needs.
Thanks again for being a part of this group. I hope it brings you lots of value.
Don’t forget the suggestions 😁
Andy
0
0 comments
Very warm welcome
powered by
skool.com/fabrication-users-7575
Got a question or stuck on something? Post here! Ask for help with CADmep, CAMduct, Revit or any fabrication task. The community is here to assist!
Suggested communities
Powered by